I was down in Brundall today on the South Broads inspecting this Landamores Elanco 37 Classic Broads Cruiser. Built in 1962, the Elanco 37 was, at that time, the largest hire cruiser one could rent on the Norfolk Broads. 'Snow Goose' is famous here on the Broads as she is one of very few surviving examples. She has a pair of modern diesel engines fitted. Also a generator has been installed that ensures that you are completely self sufficient when away form your home berth and shore power hook-up. All of the above means that she lends herself very well to being used as a liveaboard boat.
Surveyors comments on Surveying wooden boats generally:
Concealed areas within a hull are always a problem but, most wood vessels are constructed in such a way that enough access is available to make a fair assessment. It is usually possible to pull up floors (such as screwed in place plywood panels and the like) and remove enough paneling that one can get a fairly good glimpse of the bottom and lower sides. Carrying an electric screw gun is a must in order to do this quickly and effectively.
Three important tools are a slim but heavy gauge pry bar - of the sort used for pulling nails - a heavy hammer and a large standard blade screwdriver. Check the joints between planks and frames visually, looking for gaps or any sign that the plank is not tight against the frame. Then use the screw driver to test the wood for softness on both plank and frame near the mating surface. If the frame is cracked or the wood is soft, one doesn't have to go any further. Soft wood and cracked frames are dangerous conditions that mandate repair.
Concealed areas within a hull are always a problem but, most wood vessels are constructed in such a way that enough access is available to make a fair assessment. It is usually possible to pull up floors (such as screwed in place plywood panels and the like) and remove enough paneling that one can get a fairly good glimpse of the bottom and lower sides. Carrying an electric screw gun is a must in order to do this quickly and effectively.
Three important tools are a slim but heavy gauge pry bar - of the sort used for pulling nails - a heavy hammer and a large standard blade screwdriver. Check the joints between planks and frames visually, looking for gaps or any sign that the plank is not tight against the frame. Then use the screw driver to test the wood for softness on both plank and frame near the mating surface. If the frame is cracked or the wood is soft, one doesn't have to go any further. Soft wood and cracked frames are dangerous conditions that mandate repair.
No comments:
Post a Comment
Hi, how can I help?