I was back at Brooms today Surveying this Broom 30 Motor Cruiser for Pre-purchase. This was the last 30 built by Brooms and had a bigger 82HP engine.
Sharing the same round-bilged GRP hull as the Ocean 30, designed by Mr R.M. "Rip" Martins who was a naval architect, the Broom 30 is distinguished by its midships wheelhouse saloon, with sliding doors on both sides. The superstructure and interior were designed by Mr Martin Broom and four pre-1968 boats had a mahogany superstructure and teak-laid deck, after which time the construction was all GRP. Wooden uprights in the forward windscreen and wooden wheelhouse door frames were also phased out in later models.
Surveyors comment: The boats usually go through Survey well. A little osmosis is normal. Window leaks aren’t unusual on older models. Most people are surprised by the spaciousness of the interior, which provides four single berths in two cabins, a wheelhouse/saloon with a convertible settee and sunroof, two bathrooms and a 'corridor' galley. Some boats like this example have had a helm position retro-fitted to the aft cabin roof, behind the wheelhouse/saloon, increasing air draught to 9ft.
The 'Skipper' variant of the Broom 30 was produced with a soft-top and hinge-down windscreen and sides to the wheelhouse/saloon to give an air draught suitable for the Upper Thames, the Broads and other cruising grounds with low bridges. On these models, the wheelhouse is smaller, with a larger saloon and galley aft.
Engines are mostly Perkins 4-cylinder diesels ranging from 35 to 70hp in either single or twin configurations. This one was fitted with the largest engine a Perkins 4.236 82HP specifically ordered by the first owner so the vessel could be used along the coast.
Thinking of Buying a Boat and Need Help? I specialise in Boats of all types, and I will assist you to make an informed decision. Contact me for a detailed and comprehensive report at:
steventruss1@aol.com
Sharing the same round-bilged GRP hull as the Ocean 30, designed by Mr R.M. "Rip" Martins who was a naval architect, the Broom 30 is distinguished by its midships wheelhouse saloon, with sliding doors on both sides. The superstructure and interior were designed by Mr Martin Broom and four pre-1968 boats had a mahogany superstructure and teak-laid deck, after which time the construction was all GRP. Wooden uprights in the forward windscreen and wooden wheelhouse door frames were also phased out in later models.
Surveyors comment: The boats usually go through Survey well. A little osmosis is normal. Window leaks aren’t unusual on older models. Most people are surprised by the spaciousness of the interior, which provides four single berths in two cabins, a wheelhouse/saloon with a convertible settee and sunroof, two bathrooms and a 'corridor' galley. Some boats like this example have had a helm position retro-fitted to the aft cabin roof, behind the wheelhouse/saloon, increasing air draught to 9ft.
The 'Skipper' variant of the Broom 30 was produced with a soft-top and hinge-down windscreen and sides to the wheelhouse/saloon to give an air draught suitable for the Upper Thames, the Broads and other cruising grounds with low bridges. On these models, the wheelhouse is smaller, with a larger saloon and galley aft.
Engines are mostly Perkins 4-cylinder diesels ranging from 35 to 70hp in either single or twin configurations. This one was fitted with the largest engine a Perkins 4.236 82HP specifically ordered by the first owner so the vessel could be used along the coast.
Thinking of Buying a Boat and Need Help? I specialise in Boats of all types, and I will assist you to make an informed decision. Contact me for a detailed and comprehensive report at:
steventruss1@aol.com
No comments:
Post a Comment
Hi, how can I help?